3D Printing Design Challenge | Prototype a Functional Part

Identify a measured need and design, slice, print, test and revise a functional bracket, adapter, repair part, organizer or assembly component.

Design brief

Identify a small genuine need that additive manufacturing can address appropriately. Design a functional part such as a bracket, adapter, spacer, knob, cable guide, tool holder, enclosure feature, assembly connector, or low-risk repair component. Print a focused prototype, test it, and revise the model.

Required evidence

  • situation, user, need, requirements, and restrictions;
  • measurements and the source of critical dimensions;
  • alternatives and justification for using 3D printing;
  • editable CAD model and exported manufacturing file;
  • orientation and slicer decisions with a toolpath preview;
  • a fit or feature test where uncertainty is high;
  • observations from realistic use;
  • at least one model revision tied to evidence.

Appropriate scope

Avoid parts whose failure could cause injury, electrical hazard, vehicle failure, uncontrolled motion, or significant property damage unless a qualified local process explicitly supports the application. A classroom prototype is evidence for learning, not an automatic certification for service.

Evaluate process as well as part

Consider material used, support waste, print time, failed attempts, repairability, and whether another process or an off-the-shelf component would better meet the need.

Ontario curriculum relevance: Adaptable to TIJ1O, TDJ2O, TMJ2O, TEJ2O, and senior technology courses where CAD, additive manufacturing, technical problem solving, prototyping, and evaluation authentically fit the project.

Return to the General Design & Fabrication pathway or compare additive and laser-cut hybrid fabrication.