Build and Test an Ethernet Cable

networking
Ethernet
T568B
8P8C
cable tester
The complete classroom sequence for terminating an 8P8C plug in T568B order and testing the patch cable.

This is the complete step-by-step sequence from the classroom presentation.

ImportantSafety and tools

Wear safety glasses when trimming conductors. Work only on an unplugged cable. Use the demonstrated stripper, cutter, and crimper. Keep wire clippings off the floor.

Cable stripper, cable tester, punch-down tool, and modular crimper.

Tools

Cable, matching 8P8C plugs, stripper/cutter, crimper, tester, ruler, and scrap container.

Figure 1. Tools. Open source and CC BY 4.0 licence.

Eight conductors arranged in T568B order.

T568B order

Use the same order on both ends for this straight-through cable.

Figure 2. Open source and licence.

1 white-orange2 orange3 white-green4 blue5 white-blue6 green7 white-brown8 brown

Procedure

0

Measure and cut

Leave enough cable for a gentle route and a small service loop.

1

Remove the outer jacket

Strip about 25 to 40 mm. Cut lightly. Do not nick the eight insulated conductors.

2

Inspect every conductor

If copper is exposed or insulation is cut, remove the damaged section and start again.

3

Untangle and flatten

Separate the four pairs. Untwist only the length needed to reach the plug.

4

Arrange T568B

Place all eight conductors in the colour order shown above.

5

Trim to an even 13 mm

Pinch the order between your fingers. Cut the ends straight and even.

6

Insert and verify

Clip down, gold pins up, white-orange on the left. Every wire reaches the front. About 6 mm of jacket enters the plug.

7

Crimp

Insert the plug fully into the correct crimper slot. Squeeze completely using the demonstrated tool procedure.

8

Inspect the termination

All contacts sit evenly. The strain relief grips the jacket. Gently tug the cable.

9

Finish the other end and test

Use T568B again. A good tester shows pins 1 through 8 in the same order at both ends.

Outer jacket being removed from an Ethernet cable.

Steps 1 and 2

Remove only the jacket, then inspect the inner insulation.

Figure 3. Open source and licence.

Twisted pairs separated for Ethernet termination.

Step 3

Separate the pairs and keep the untwisted length short.

Figure 4. Open source and licence.

Ethernet conductors aligned before entering the modular plug.

Steps 4 to 6

Order, flatten, trim, insert, and check through the clear plug.

Figure 5. Open source and licence.

A photo sequence showing an 8P8C plug being inserted and crimped.

Steps 7 and 8

Crimp fully. Check contact height and strain relief before testing.

Figure 6. Public-domain visual sequence. Open source.

Network cable tester used for modular Ethernet cables.

Step 9

Test for correct order, opens, shorts, reversals, crossed pairs, and split pairs.

Figure 7. Open source and licence.

Final quality check

  • T568B order on both ends.
  • No exposed copper or cut insulation.
  • Every conductor reaches the front.
  • Jacket is under the strain relief.
  • All contacts are evenly crimped.
  • Tester shows 1 through 8 in order.

Evidence

Take five photos: stripped jacket, flattened T568B order, head-on view before crimping, finished connector, and tester result.

Return to Networking