Component Foundations 2: Resistors
Learning goals
- I can distinguish the physical resistor from the quantity resistance.
- I can read resistance, tolerance, and power information.
- I can use Ohm’s law and a power equation to check a resistor choice.
- I can measure resistance safely with circuit power removed.
Resistance and resistors
Resistance is opposition to current. Its symbol is \(R\) and its unit is the ohm (\(\Omega\)). A resistor is a component manufactured to provide a useful resistance.
Resistors are used to:
- limit current;
- create voltage dividers;
- set transistor and amplifier operating conditions;
- define logic inputs;
- convert electrical energy into heat within a rated limit.
A resistor is normally non-polarized, so either lead may face either direction. Its value and power rating still matter.
What is inside?
Common through-hole resistors use a resistive film formed around an insulating body, with metal end caps and leads. The material and geometry determine resistance. Open Circuits can be used in class to inspect truthful internal construction; public notes use original descriptions rather than copied cutaways. [2]
Value, tolerance, and power
A resistor description such as 4.7 kΩ, ±5%, 0.25 W contains three different limits:
- 4.7 kΩ is nominal resistance;
- ±5% is the permitted manufacturing range;
- 0.25 W is the maximum power rating under stated conditions.
For 4.7 kΩ at ±5%, the resistance can reasonably fall between \(4.465\,\text{k}\Omega\) and \(4.935\,\text{k}\Omega\).
The common four-band colour code for 4.7 kΩ ±5% is yellow, violet, red, gold. Always confirm unfamiliar codes with the course reference or a meter.
Equations
Ohm’s law connects voltage, current, and resistance:
\[V=IR\]
Resistor power can be checked with:
\[P=VI=I^2R=\frac{V^2}{R}\]
Choose a resistor rating comfortably above the expected operating power. A calculated value below the printed rating is not permission to ignore temperature, enclosure, ventilation, pulses, or manufacturer derating.
Example: LED current limiting
For a 5.0 V source and an LED with an approximate 2.0 V forward drop, a 330 Ω series resistor has about 3.0 V across it:
\[I\approx\frac{5.0\,\text{V}-2.0\,\text{V}}{330\,\Omega}=9.09\,\text{mA}\]
The resistor power is about:
\[P_R=I^2R\approx27.3\,\text{mW}\]
This simplified calculation is a design estimate. The real LED forward voltage and resistor value vary.
Five-question starter
- Explain the difference between resistance and a resistor.
- State the nominal value, tolerance, and power rating of a 2.2 kΩ, ±5%, 0.25 W resistor.
- Calculate the possible resistance range of a 1.0 kΩ ±5% resistor.
- A 9.0 V source is connected across 1.0 kΩ. Calculate current and resistor power.
- A student selects a 100 Ω resistor for a 5.0 V LED circuit with a 2.0 V LED drop. Calculate the estimated current and resistor power, then explain what else must be checked before building.
Jupyter and lab pathway
- Use Notebook 1 for Ohm’s law and power.
- Use Notebook 4 to sweep resistance and graph current.
- Adapt Grob Experiments 2-1 and 2-2 for identification and meter comparison.
- Measure resistance only with power removed and stored energy discharged.
Textbook support: Grob, Chapter 2, pp. 54-70. Practice support: Grob Problems Manual, Chapter 2. [1, Ch. 2]